Warning Messages - Kenwood TS-890S Instruction Manual

Hide thumbs Also See for TS-890S:
Table of Contents

Advertisement

Warning Messages

The following warning messages are displayed in the event of an erroneous operation or when a problem on this transceiver is detected.
Follow the steps described for each warning message to resolve the problem. If "Troubleshooting" is indicated in the warning message
or when the problem cannot be resolved, please refer to the list of error messages and "Troubleshooting" (18-2).
ID
000C
This audio file cannot be reproduced. (WR: 000C)
Due to insufficient memory of the data storage or the write
protection of the USB flash drive, the data storing process was
0031
terminated. (WR: 0031)
Ensure that there is sufficient memory and that data storage has
been enabled.
0032
Selects the days of the week. (WR: 0032)
A maximum of 4 hours of recording time can be configured. (WR:
0033)
0033
Ensure that the Power-on Time and Power-off time are
appropriate.
The same clock time cannot be configured for both the Power-on
Time and Power-off Time. (WR: 0034)
0034
Ensure that the Power-on Time and Power-off Time are
appropriate.
Failure in formatting of a USB flash drive has been detected. (WR:
0039)
The failure may be caused by one or more of the following:
• The write protected USB flash drive is connected to a USB
0039
connector.
• The USB flash drive is not correctly connected to a USB
connector.
• The security-protected USB flash drive is connected to a USB
connector.
0043
The file cannot be accessed while recording data. (WR: 0043)
004A
Select copy item. (WR: 004A)
0053
Select delete item. (WR: 0053)
The Programmable Timer is about to start recording the received
audio. (WR: 0101)
The recording can begin if the transceiver has been turned OFF.
0101
If the USB flash drive has selected as the file storage location,
connect a USB flash drive to the USB connector before recording
starts.
Recording by the Programmable Timer.(WR: 0102)
0102
To stop recording, press and hold [(BREAK)] (F).
High temperature has been detected in the transmitter. Refer to
"Troubleshooting" in the instruction manual (WR: 0104).
0104
To prevent the transmitter from being damaged, the transmit
power has been reduced to 5 W.
Very high temperature has been detected in the transceiver. Refer
to "Troubleshooting" in the instruction manual (WR: 0106).
0106
Transmission capability is disabled until the transceiver cools
down.
Message
TROUBLESHOOTING 18
Description/Corrective Action
Appears when the format of the wav file is not supported by this
transceiver.
Check the file format on a PC to see if the file is in the wav format that
can be played on this transceiver.
Appears when the maximum number of files in each folder has been
exceeded, insufficient memory space or writing forbidden is detected
when writing a file.
Appears when [OK] is pressed with all the days of the week unchecked
on the program timer configuration screen.
Appears when [OK] is pressed with the time limit exceeded when
configuring the Power-on Time and Power-off Time on the program timer
configuration screen.
Appears when [OK] is pressed with an invalid time range configured for
this transceiver on the program timer configuration screen.
Appears when formatting of the USB flash drive failed.
Follow the instructions in the message.
Appears when attempting to read a log file for which recording is
currently in progress.
Appears when attempting to copy files to a PC with all the files
unchecked on the screen for selecting the files to copy.
Appears when attempting to delete files while all the files are unchecked
on the screen for selecting the files to delete.
Appears when the power of this transceiver is turned on approximately
3 minutes and 1 minute before timer recording starts. Follow the
instructions in the message.
Appears when [
] is pressed and held down during timer recording
while the screen is turned off.
Stop the transmission and allow the temperature of this transceiver to
go down.
Is the ambient temperature of this transceiver high (such as when the
transceiver is exposed to direct sunlight)? Please operate it in a well-
ventilated place.
18-11

Advertisement

Table of Contents
loading

Table of Contents