Troubles Related To Recording And Playback - Kenwood TS-890S Instruction Manual

18 TROUBLESHOOTING

Troubles Related to Recording and Playback

Symptom
A message is displayed when [
pressed during timer recording.
A file is created after executing timer
recording but the RX audio cannot be
heard.
Voice messages cannot be recorded. The input path for the audio is not correctly
The voice message repeat interval is
not functioning.
RX audio can only be recorded for 30
seconds.
WAV files cannot be played.
The playback volume is very soft.
18-8
Probable Cause
] is Timer recording is in progress.
The mute function is ON when timer recording
is performed.
configured.
An attempt has been made to execute repeat
interval for playing back voice messages only.
Repeat is turned off.
Full-time recording is enabled.
The format is not supported by this transceiver. The format supported by this transceiver is as
The [AF] control is turned all the way to the left. Turn the [AF] control to the right to adjust the
Corrective Action
To stop timer recording and allow this
transceiver to be operated, press and hold F4
[(BREAK)]. To continue with timer recording,
press [ ].
Check whether the mute function is ON when
timer recording is performed. RX audio will not
be recorded if mute is ON.
Check on the voice message recording standby
screen to ensure that the audio input path is
correct and the level is not too high or too low.
Repeat interval functions during playback with
transmission. It does not function during
playback without transmission.
Configure repeat to ON for the channel to
repeat.
Full-time recording records only up to 30
seconds regardless of the destination for
saving the file.
follows.
No. of channels: 1 (monaural), No. of bits: 16,
sampling frequency: 16 kHz
volume.
Refer to
14-4
14-4
12-1
12-2
12-3
12-4
4-2