Adjusting The Touchscreen; Adjusting The Display Color - Kenwood TS-890S Instruction Manual

Adjusting the Touchscreen

Follow the steps below to adjust the contact points on the touchscreen
to prevent false recognition when touching the touchscreen. Adjust
the touchscreen if the frequency of false recognitions has increased
with time.
1 Select Advanced Menu [23] "Touchscreen
Calibration".
2 Press F4 [SELECT].
3 Touch the "+" marks that are displayed on the
screen in sequence.
A "+" mark is displayed in sequence at the four corners of the
screen. After touching all the "+" marks at the four corners and
the center, touchscreen adjustment is complete and the
Advanced menu screen is displayed.
.
Touchscreen adjustment cannot be performed during
●
transmission.
Touchscreen adjustment cannot be stopped halfway.
●
Make sure to touch the "+" marks at the four corners and
the center in sequence.
If touchscreen adjustment is interrupted due to
●
unforeseen circumstances such as power outage,
perform the adjustment again.
MAINTENANCE AND ADJUSTMENT 17

Adjusting the Display Color

The color tone of the display can be adjusted as follows.
1 Turn off the power of this transceiver.
2 Pressing and holding [CLR] while turning on the power
displays the display color adjustment screen.
.
3 Use the controls below to adjust the color.
Control
Changes the red level.
[KEY] (Turning the [DELAY] control resets the value
to "0".)
Changes the green level.
[MIC/PITCH] (Turning the [POWER] control resets the value
to "0".)
Changes the blue level.
[HI/SHIFT] (Turning the [LO/WIDTH] control resets the
value to "0".)
Setting Value -15 to 0 (default) to +15 (1 step)
4 Turn off the power of this transceiver.
When this transceiver is operated with a control other
●
than those above, the display color adjustment screen
disappears temporarily and the adjusted color tone can
be previewed on the normal screen.
Behavior
17-3