Table of Contents
Advertisement
(1)
Vertical feet position (bold colored tolerance arrows show direction to move/correct
l
machine feet)
(2)
Horizontal feet position (bold colored tolerance arrows show direction to move/-
l
correct machine feet)
(3)
Vertical coupling results
l
(4)
Horizontal coupling results
l
(5)
Selected results mode
l
(6)
Alignment condition tolerance icon
l
(7)
Used to select Horizontal and Vertical feet and coupling results in 3D / 2D
l
(8)
Save asset measurement results
l
(9)
Create asset measurement result report
l
(10)
Show asset measurement table
l
l
(11)
Tap
Taking measurement points automatically
Measurement points may be taken automatically if the default setting item "Take points auto-
matically after stabilization" has been activated. The item 'Default settings' is found under
"Configuration".
The initial measurement is taken by tapping either the pulsating M or
bilization.
When the rotational angle of the sensor and reflector is within the sector range, a series of dots
in circular motion (1) indicate the stabilization process. Once this occurs stop the rotation of
the shafts and wait for the pulsating M to appear.
Shop for Fluke products online at:
to start Live Move
MyFlukeStore
www.
On-board help
after sta-
1.888.610.7664
.com
Advertisement
Table of Contents
