Suggested Consolidated Shaft Alignment Tolerances - Fluke 831 User Manual

On-board help
Select necessary coupling format, then tap the item "Tolerances" to view tolerances based on
the selected coupling format.
[1] shows the tolerance table for the given short flex coupling and RPM. The coupling format is
angle/offset.
[2] shows the tolerance table for the given short flex coupling, diameter and RPM. The coup-
ling format is gap/offset.
Note
There are no tolerance tables for consolidated spacer shaft coupling formats. Con-
solidated formats consider the spoolpiece or jackshaft as an extension of either the right
or left shaft.

Suggested consolidated shaft alignment tolerances

The following table shows the consolidated (50 Hz and 60 Hz) tolerances
Shop for Fluke products online at:
MyFlukeStore
www.
1.888.610.7664
.com