Table of Contents
Advertisement
Live Move – Vertical machines
Alignment is carried out by correcting angularity and offset.
(1)
Shim at the given bolt locations to correct angularity.
l
(2)
Move the machine laterally to correct offset.
l
Correct angularity
We recommend (but not obligatory) angularity corrected first:
1. Loosen the flange bolts then lift the movable machine.
WARNING
The machine bolts must be undamaged and removable.
2. Angularity corrections are made by shimming. The shimming values at the respective bolt
positions are shown on the screen. Insert (or remove) shims with the correct thickness under
the selected bolt. Loosen the flange bolts then lift the movable machine.
3. Tighten the bolts back down, then take another set of readings to confirm shimming cor-
rections; repeat shimming if necessary.
4. Once satisfied that overall angular misalignment is in tolerance, and no more shimming is
required, proceed to correct offset.
Correct offset
1. Use the Live Move function to make offset corrections.
Shop for Fluke products online at:
MyFlukeStore
www.
On-board help
1.888.610.7664
.com
Advertisement
Table of Contents
