Table of Contents
Advertisement
On-board help
Machine properties
These lifelike machine graphics are available:
1. Generic standard machine; 2. Motor; 3. Pump; 4. Split case pump; 5. Fan; 6. Center hung
fan; 7. Blower; 8. Compressor; 9. Gearbox; 10. Rotor gearbox; 11. Diesel engine; 12. Gen-
erator; 13. Gas turbine; 14. Shaft with no supports; 15. Shaft with a single support; 16. Shaft
with two supports
From the dimensions screen, tap the machine to access the respective machine carousel.
Swipe the machine carousel [1]up or down and select desired machine. Position desired
machine at the centre of the carousel then tap
to confirm selection and return to the
dimensions screen.
Toggle
"Toggle" is used change the orientation of the selected machine along the shaft axes. In the fol-
lowing example, the motor has been flipped so as to connect the non-drive side to the coup-
ling.
Machine color
The desired machine color may be set from this screen by tapping the item "Machine color". A
color palette is shown.
MyFlukeStore
1.888.610.7664
www.
.com
Shop for Fluke products online at:
Advertisement
Table of Contents
