Table of Contents
Advertisement
On-board help
Dimensions
From the home screen, tap
screen.
(1)
Grayed out icons are disabled within the active screen. The 'Measure' icon is enabled
l
after all dimensions have been entered.
l
(2)
Tap the measurement units icon
between "inch" and "mm".
(3)
Tap the slider on the mini train icon to open the triple "Train Manager" / "Train
l
Setup" / "Train Fixation" screen.
Note: "Train Manager" is not active. See section on train setup and fixation for details.
Tap the dimension fields and enter all required dimensions. The user may elect to tap
the 'Next' button to proceed to enter next dimension. Dimensions may be entered only when
the dimension field is highlighted blue.
Note
If units are set to Imperial system, inch fractions may be entered as follows: For
enter 1/8 = 0.125"; For 10
The coupling diameter value may be determined by entering the measured cir-
cumference of the coupling and dividing the value by π (pi) (=
3.142). For example 33"/π = 10.5"; Or 330 mm/π = 105 mm
The rotate machine view icon
ponents on the display.
Machine and coupling properties may be edited by tapping the respective machine or coupling.
When all required dimensions have been entered, the 'Measure' icon
Shop for Fluke products online at:
the horizontal alignment icon to access the dimensions
to set desired units. The icon toggles
3
/
" enter 10 + 3/8 = 10.375".
8
is used to rotate the view of the machines and mounted com-
MyFlukeStore
www.
1
/
"
8
comes into view.
1.888.610.7664
.com
Advertisement
Table of Contents
