On-board help
(L)
Lever
The yellow knob on the front of the reflector allows you to adjust the horizontal angle of
the reflected laser beam. Before you mount the reflector make sure that this knob is
centered to allow for maximum adjustment range later on. The bottom of the knob
should be flush with the arrow marking on the reflector housing.
(M)
Arrow marking
Match the height of the yellow knob approximately to the tip of the arrow
Flip up the quick-release lever on the side of the reflector housing, then slide the
l
reflector onto the right-hand bracket posts. Return the lever to its horizontal position to
secure the reflector on the posts.
MyFlukeStore
1.888.610.7664
www.
.com
Shop for Fluke products online at: