Installing The Baffle And Blower Support - Toro 79348 Manual

Figure 5
1. Rod
2. Cotter pin (CE models
only)
3. Spring
3. Remove the deflector
4. Pull up the side of the cover with the grommet
and slide the cover off.
Figure 6
g466323
4. Deflector
5. Deck brackets
6. Spring installed over the
rod
(Figure 5).
(Figure 6).
g454740
4
Installing the Baffle and
Blower Support
Parts needed for this procedure:
1 Blower support
2 Hex washer-head screw (3/8 x 3/4 inch)
1
Baffle
4 Carriage bolt (5/16 x 3/4 inch)
4 Flange nut (5/16 inch)
Procedure
1. Install the blower support to the mower deck
using 2 hex washer-head screws (3/8 x 3/4 inch)
as shown in Figure
1. Hex washer-head screw
(3/8 x 3/4 inch)
9
7.
Figure 7
2. Blower support
g201299