Removing The Grass Deflector And Belt Cover - Toro 79348 Manual

Figure 3
1. Right weight-mount
2. Bolt (3/8 x 1 inch)
2. Install the bagger weights (amount determined
by deck size) to the weight mounting bracketsto
the weight mounts with 2 bolts (3/8 x 2-3/4
inches), washers, and locknuts (3/8 inch) as
shown in Figure 4.
Deck Size Plates Required*
48-inch 3
54-inch 2
60-inch 1
Important:
Adjust the amount of weight
according to the size of the mower deck.
Figure 4
1. Bolt (3/8 x 2-3/4 inches)
2. Washer
g462067
3. Locknut (3/8 inch)
4. Left weight-mount
g462068
3. Bagger weights
4. Locknut (3/8 inch)
3
Removing the Grass
Deflector and Belt Cover
No Parts Required
Procedure
WARNING
An uncovered discharge opening could allow
the machine to throw objects toward you or
bystanders and result in serious injury. Also,
contact with the blade could occur.
Never operate the lawn mower unless you
install a mulch plate, discharge deflector, or
grass-collection system.
Inspect the grass deflector for damage before each
use. Replace any damaged parts before use.
1. Set the height of cut at the lowest cutting
position.
2. Disengage the spring from the notch in the
deflector bracket and remove the cotter pin (CE
models only), slide the rod out of the welded
deck brackets, spring, and discharge deflector
(Figure 5).
Note:
Your chute may look different than the
one pictured.
8