Installing The Latch Rod - Toro 79348 Manual

Note:
Repeat this step for both sides of the
machine.
6. With the rod fully seated in the frame, adjust the
position of the clevis at the end of the rod so
it aligns with the tab on the side of the bagger
frame.
Figure 16
Left side shown
1. Rod fully seated in the
frame
7. Secure the ends of the rods to the bagger frame
as shown in Figure 16
each rod with a clevis pin and a hairpin.
g462501
2. Clevis adjusted to the side
of the bagger frame
and secure the end of
7

Installing the Latch Rod

Parts needed for this procedure:
1 Latch rod
1 Hairpin cotter
Procedure
Install the latch rod with a hairpin cotter
1. Hairpin cotter
2. Latch rod
13
(Figure
Figure 17
3. Latch rod hole
17).
g465962