Honeywell N4680 User Manual page 232

•
Is the bar code displayed but not entered?
The bar code is displayed on the host device correctly, but you still have to press a
key to enter it (the Enter/Return key or the Tab key, for example).
You need to program a suffix. Programming a suffix enables the scan engine to
output the bar code data plus the key you need (such as "CR") to enter the data into
your application. Refer to "Prefix/Suffix Overview" on page 4-59 for further infor-
mation.
Does the scan engine read the bar code incorrectly?
If the scan engine reads a bar code, but the data is not displayed correctly on the
host screen:
•
The scan engine may not be programmed to output your bar code data properly.
For example, you scan "12345" and the host displays "A12345B."
Reprogram the scan engine with the proper symbology selections. See
The scan engine won't read your bar code at all.
1. Scan the sample bar codes in the back of this manual. If the scan engine reads
2. If the scan engine still can't read the sample bar codes, scan
If you aren't sure what programming options have been set in the scan engine, or if
you want the factory default settings restored, scan
on page 179.
212
Are enabled in the scan engine or in the decoder to which the scan engine
connects.
The scan engine may not be programmed for the appropriate terminal interface.
For example, you scan "12345" and the host displays "@es%."
Reprogram the scan engine with the correct Plug and Play or Terminal selection
bar code. See Chapter 2
the sample bar codes, check that your bar code is readable.
Verify that your bar code symbology is enabled (see
Symbologies" on page
and Chapter 3.
6-86.
N4680 2D Decoded Scan Engine User Guide
Chapter
Chapter 6).
"All
Resetting the Factory Defaults
6.