Table of Contents
Advertisement
Addenda Timeout
You can set a time during which the scanner looks for an addenda. If an addenda is
not found within this time period, the data can be either transmitted or discarded,
based on the setting you are using for
the length (in milliseconds) for this timeout by scanning the bar code below, then
setting the timeout (from 0-65535 milliseconds) by scanning digits from the
Programming
UPC-A Addenda Separator
When this feature is on, there is a space between the data from the bar code and
the data from the addenda. When turned off, there is no space. Default = On.
UPC-A/EAN-13 with Extended Coupon Code
Use the following codes to enable or disable UPC-A and EAN-13 with Extended
Coupon Code. When left on the default setting (Off), the scanner treats Coupon
Codes and Extended Coupon Codes as single bar codes.
If you scan the Allow Concatenation code, when the scanner sees the coupon
code and the extended coupon code in a single scan, it transmits both as one sym-
bologies. Otherwise, it transmits the first coupon code it reads.
If you scan the Require Concatenation code, the scanner must see and read the
coupon code and extended coupon code in a single read to transmit the data. No
data is output unless both codes are read. Default = Off.
N4680 2D Decoded Scan Engine User Guide
Chart, then scanning Save. Default = 100.
* On
* Off
UPC-A Addenda Required
Addenda Timeout
(page 6-110). Set
Off
Allow Concatenation
111
Advertisement
Table of Contents
