Table of Contents
Advertisement
Application Plug-Ins (Apps)
Any apps that you are using can be turned off or on by scanning the following bar
codes. Apps are stored in groups: Decoding, and Formatting. You can enable and
disable these groups of apps by scanning that group's On or Off bar code below.
You can also scan the List Apps bar code to output a list of all your apps.
Note: You must reset your device in order for the apps setting to take effect.
EZConfig-Scanning Introduction
EZConfig-Scanning provides a wide range of PC-based programming functions
that can be performed on a scan engine connected to your PC's COM port. EZCon-
fig-Scanning allows you to download upgrades to the scan engine's firmware,
change programmed parameters, and create and print programming bar codes.
Using EZConfig-Scanning, you can even save/open the programming parameters
for a scan engine. This saved file can be e-mailed or, if required, you can create a
single bar code that contains all the customized programming parameters and
mail or fax that bar code to any location. Users in other locations can scan the bar
code to load in the customized programming.
To communicate with a scan engine, EZConfig-Scanning requires that the PC have
at least one available serial communication port, or a serial port emulation using a
physical USB port. If you are using the serial port and RS232 cable, an external
power supply is required. When using a USB serial port emulation, only a USB
cable is required.
N4680 2D Decoded Scan Engine User Guide
* Decoding Apps On
* Formatting Apps On
List Apps
Decoding Apps Off
Formatting Apps Off
177
Advertisement
Table of Contents
