Table of Contents
Advertisement
7-1. INTRODUCTION
7-2. This section contains information necessary to adapt this manual to older instruments. Also
included is information for available options. Options are covered starting with paragraph 7-9.
Field installation of options are covered in paragraph 7-19. Refer to Section I1 for ASCII remote
programming information.
7-3. MANUAL CHANGES
7-4. This manual applies directly to Model 5340A with serial prefix 1532A. See paragraph 1-4
for serail number identification.
7-5. Newer Instruments
7-6. As changes are made, newer instruments may have serial prefixes that are not listed in this
manual. The manual for these instruments are supplied with a manual change sheet which con-
tains the required updating information. If this sheet is missing, contact the nearest Hewlett-
Packard Sales and Service Office listed
7-7. Older Instruments
7-8. To adapt this manual to instruments having serial prefixes below 1532A, refer to Table 7-1
for backdating that applies to your instrument serial prefix.
3
CHANGE 1
Table 6-1, A2A4 Replaceable Parts:
Change
series
Change A2A4C20 and A2A4C22 to 0160-0363 C:FXD MICA 620PF 5%, 28480,0160-0363.
Change A2A4C21 to 0160-2202 C:FXD MICA 75PF 5%, 28480,0160-2202.
Change A2A4L8 and A2A4L10 to 9100-2244 CO1L:FXD
Change A2A4L9 to 9140-0158 1UH
Table 6-1, A2 Parts List:
Delete C8 and descriptipn.
Table 6-1, A4 Replaceabie @arts:
Change series num ei'for 05340-60002 (A4) to 1220A.
Change A4R22 to
that some A4 boards with series 1220A may have 1800 ohm resistors installed).
SECTION VII
MANUAL CHANGES AND OPTIONS
at
the back of this manual.
Table 7-1. Manual Backdating
If Your Instrument Has
Serial Prefix
number for 05340-60040 (A2A4) from 1532 to 1344A.
99800, 1025-20.
757-0932 R:FXD MET FLM 2.2K
Manual Changes and Options
Make the Following Changes
to Your Manual
1
RF
OHM
2% 1/8W, 28480, 0757-0932 (Note
Model 5340A
7-1
Advertisement
Table of Contents
Troubleshooting
