Table of Contents
Advertisement
Nellcor N1000 and N2500 Multi-Function Monitor
176
3. Put Cable 1 through the sleeve in A
the connector hood, so that the cable cannot be torn out. Repeat this
procedure for all the other cables. (As there are only 5 holes, two cables must
be fitted through single holes in two cases).
4. Connect the black and white wires that are twisted together to the shield
wires of all the cables. Do NOT separate these wires.
5. Connect the brown wire of the Free Analog cable to the signal wire of Cable
1 for Numeric 1. Continue for all cables as shown in the table opposite.
6. Label each cable (1 to 7)
.
VueLink Free Analog Cable
Channel
Wire Colours
---
Black and White
(twisted)
---
Black (thick)
Wave 1
Brown
Wave 2
Red
Numeric 1
Orange
and crimp the sleeve on the inside of
1
Designation
Analog
1-7
ground
Shield
Black & White
Pleth
1
CO
2
2
SpO
3
2
Free Analog Device Information
Cable
Advertisement
Table of Contents
