Table of Contents
Advertisement
Dräger Evita Ventilator
Step 2: Prepare the free analog cable
Note
160
(45 Minutes)
1. Connect the black and white wires that are twisted together to the Evita
Analog ground (Evita pin 1). Do NOT separate these wires.
2. Connect the thick black wire, or the copper shield, to the case resp. ground
on the device (Evita pin 32).
If there is a conductive connection from the copper shield, via the connector, to the
case resp. ground, then the black wire does not need to be connected.
3. Connect the colored wires to the analog output connector on the external
device. The respective channels for each wire color are given in the following
table.
Free Analog Device Information
Advertisement
Table of Contents
