Table of Contents
Advertisement
110
7.3
Assembling the stand
Fig. 51: Assembling the stand
①
②
③
④
(1) - Inner bar
(2) - Holder for oil can
(3) - Adjusting screw
(4) - Stand bar
To assemble the stand:
1.
Screw the cross bar (7) to the stand bars (4).
2.
Screw the oil can holder (2) at the rear to the upper cross
bar (7).
3.
Screw the cross strut (6) to the foot struts (5).
4.
Insert the inner bars (1) in such a way that the longer end
of the head section (8) is above the longer end of the foot
struts (5).
5.
Tighten the inner bars (1) down so that both head sections
(8) are at the same height.
Important
Turn the adjusting screw (3) so that the stand has even contact
with the ground.
Operating Instructions 667 PREMIUM - 02.0 - 01/2018
⑧
⑤
(5) - Foot strut
(6) - Cross strut
(7) - Cross bar
(8) - Head section - inner bar
Setup
①
④
⑦
⑤
⑥
Advertisement
Table of Contents
