Table of Contents
Advertisement
(2)
(3)
(4)
(5)
(6)
(7)
(11)
(12)
(13)
(14)
(1)
(8)
(9)
(10)
(15)
MONOGRAMMING
You can program letters and symbol designs for
monogramming.
Press the monogramming tab and the font selection
window will open.
(1) Monogramming tab
You can select one of 6 fonts.
Select the desired font by pressing the corresponding
key.
(2) Block key
(3) Script key
(4) Broadway key
(5) Block (9 mm) key
(6) Cyrillic key
(7) Symbol key
The monogram mode window will open.
NOTE:
The height of Block (9 mm) is approximately 9 mm.
Function Keys
(8) Save file key
Press this key to save the monogram as a data file.
(9) Preview key
Press this key to view the entire monogram.
(10) Pattern combination length key
Press this key to check the total length of the entire
monogram.
(11) Delete key
Press this key to delete the selected characters.
(12) Cursor keys
Press the cursor key to move the cursor up or down.
(13) Letter size key
Press this key to select the full size (L) or small size (S).
(14) Letter case key
Press this key to select the upper case or lower case.
(15) Character type key
Press this key to select the character type among
alphabets, numerals, symbols and European characters.
NOTE:
Numbers, symbols and European letters are available
on pages 2/5 through 5/5.
97
Advertisement
Table of Contents
