ELNA eXcellence 792PRO Instruction Book page 88

3.
4.
6.
7.
9.
11.
(1)
1.
2.
5.
8.
10.
86
Place two spools of thread on the spool stand.
To thread the left spool thread, draw the thread from the
left spool and pass it through the threading points from 1.
and 3. to 6.
Slip the thread through the slit of the lower thread guide
7., (behind the hole of the lower thread guide) then pass
through points 9. and 11. as illustrated.
To thread the right spool thread, draw the thread from the
right spool and pass it through the threading points from 1.
to 6.
Draw the thread through the hole of the lower thread
guide 8., then pass the thread to the point 10. as
illustrated.
Make sure that the two strands of thread from the spools
do not get tangled.
NOTE:
• Threading from points 3. to 6. is the same as for a
single needle (refer to pages 30-31).
• The needle threader cannot be used with the twin
needle.
After twin needle sewing is finished, press the twin
needle key and the warning message will appear.
Replace the twin needle with a single needle.
Press the OK key.
(1) Twin needle key