Table of Contents
Advertisement
6.
(9)
6. Sew the fabric while guiding it with your hands.
* The A.S.R. foot holder also can be used with ruler work
(7)
or variable zigzag (refer to pages 128 and 129).
7. Be sure to pull out the A.S.R. plug from the
NOTE:
• Set the speed control slider at the fastest position
• Sewing results may vary depending upon sewing
• The machine sews at low speed when you are not
• Accurate Stitch Regulator sensor cannot detect
(8)
• The machine sews at low speed in the area 2 cm
• Regularly check if the inside of the sensor on the
• Regularly clean the black window on the underside
Adjusting stitch length
The stitch length varies depending on (the color or
thickness of) the fabric or the presser height.
Press the adjust key to adjust stitch length.
Press the "+" key to increase the stitch length.
Press the "–" key to decrease the stitch length.
(9) Stitch length adjusting key
(−)
(+)
NOTE:
The adjustable range of stitch length is 1.00 mm to
4.00 mm.
NOTE:
Remove the A.S.R. from the sewing machine when
you use the semi-hard fabric cover.
126
The status indicator will turn red during operation.
The buzzer sounds and the stitch length will be
longer than the setting when the fabric moves too
fast.
(7) Status indicator
attachment connector on the back of the machine to
remove the A.S.R. foot holder.
(refer to page 14).
conditions. Always make a test stitch on an extra
piece of fabric to check sewing results. Move the
speed control slider to set the sewing speed to
middle if the stitch length become too short when
the fabric guiding with your hands.
guiding fabric.
fabric movement in the area 2 cm (3/4˝) from the
rear side edge of the fabric (the sensor only can
detect the fabric movement under the sensor).
(3/4˝) from the edge of the fabric.
underside of the A.S.R. foot holder is not dirty.
of the A.S.R. foot holder with a soft cloth.
(8) Sensor
Advertisement
Table of Contents
