1.
2.
1. 2.
(5)
(4)
(2)
(1)
(2)
(1)
(6)
Adjusting the horizontal position of the thread cutter
switch
1. Loosen the setscrews B under the switch.
(1) Setscrew B
(2) Washer
2. Slide the switch to the left or right, and fix it at the
desired position by tightening the setscrews B with a
screwdriver.
Adjusting the vertical position of the thread cutter
switch
1. Remove the setscrews B and washers.
2. Move the switch forward or backward, attach the
switch at the desired position and fix it with the
(3)
setscrews B and washers.
(1) Setscrew B
(2) Washer
(3) Desired position
NOTE:
• To fix the thread cutter switch at its lowest position,
fix the setscrews B into the hole (4), and then holes
(5).
• Tighten the setscrews B securely.
• Peel off the backing paper from the rubber sole (6)
and attach it to the bottom of the thread cutter switch
as shown.
9 9