Installation; Operating Conditions; Space Requirements For Machine Operation And Maintenance; Tool Kit Supplied With The Machine - 3M -MATIC 8000a-T Instructions Manual

7-INSTALLATION

7.1 Operating Conditions

The machine should operate in a dry and relatively
clean environment (See Specifi cations).
7.2 Space Requirements for Machine Operation
and Maintenance Work
Minimum distance from wall (Figure 7-1):
A = 1000mm.
B = 700mm.
Minimum height = 2700mm.

7.3 Tool Kit Supplied with the Machine

A tool kit containing some tools are supplied
with the machine. These tools should be
adequate to set-up the machine, however,
other tools supplied by the customer will be
required for machine maintenance.
8000a-8000a3 - NA
B
Figure 7-1
A
Figure 7-2
To reduce the risk associated with
•
mechanical and electrical hazards:
− Allow only properly trained and
qualifi ed personnel to operate and
service this equipment.
•
To reduce the risk associated with
muscle strain:
−
Use the appropriate rigging and
material handling equipment when
lifting or repositioning this equipment.
−
Use proper body mechanics when
removing or installing taping heads
that are moderately heavy or may be
considered awkward to lift.
7.4 Machine Set-Up / Bed Height
1 - Lift the machine with belts or ropes paying attention
to place the belts in the points (Figure 7-2).
To set the machine bed height, do the following:
2 - Adjust machine bed
height. The case
sealer is equipped
with four (4) adjust-
able legs that are
located at the cor-
ners of the machine
frame.
The legs can be
adjusted to obtain
different machine
bed heights
(Figure 7-3).
Also refer to the
"Specifi cations" section.
3 - Lock the screws.
4 - Repeat the operation
for all legs.
(It is not necessary
to fi x or anchor the
machine to the fl oor).
5 - For Outer Column Repositioning -
See Special Set-up Procedure (Section 11).
18
WARNING
WARNING
Figure 7-3
2014 June