Installation; Operating Conditions; Space Requirements For Machine Operation And Maintenance; Tool Kit Supplied With The Machine - 3M -Matic 700r3 Instructions And Parts List

7-INSTALLATION

7.1 Operating Conditions

The machine should operate in a dry and relatively
clean environment (See Specifi cations).
7.2 Space Requirements for Machine Operation
and Maintenance Work
Minimum distance from wall (Figure 7-1):
A = 1000mm.
B = 700mm.
Minimum height = 2700mm.
B
A
Figure 7-1

7.3 Tool Kit Supplied with the Machine

A tool kit containing some tools are supplied
with the machine. These tools should be
adequate to setup the machine, however,
other tools supplied by the customer will be
required for machine maintenance.
Figure 7-2
700r3-NA
•
To reduce the risk associated with
muscle strain:
−
Use the appropriate rigging and
material handling equipment when
lifting or repositioning this equipment.
−
Use proper body mechanics when
removing or installing taping heads
that are moderately heavy or may be
considered awkward to lift.

7.4 Machine Positioning / Bed Height

1 - Lift the machine with belts or ropes paying atten-
tion to place the belts in the points (Figure 7-2).
To set the machine bed height, do the following:
Adjust machine bed height. The case sealer is equipped
with four (4) adjustable legs that are located at the
corners of the machine frame. The legs can be adjusted
to obtain different machine bed heights from 610mm [24
inch] minimum to 890mm [35 inch] maximum.
Note – Minimum machine bed height can be
reduced to 570mm [22.5 inch] by moving
outer columns up one set of mounting
holes. However, this change also
increases minimum box height of 120 mm
[4.8 inch] to 170mm [6.8 inch].
Refer to Figure 7-3
and set the machine bed height as follows:
2. Loosen, but do not remove, two (2)
M8 x 1.25 socket head screws in one leg
(use M6 hex wrench). Adjust the leg length
for the desired machine bed height.
Retighten the two (2) screws to secure the leg.
Adjust all four (4) legs equally.
M8 x 1.25mm
Socket Head
Screws
Adjustable
Legs
Figure 7-3
19
WARNING
2012 January