Installation; Operating Conditions; Space Requirements For Machine Operation And Maintenance; Tool Kit Supplied With The Machine - 3M 40800 Instructions And Parts List

7-INSTALLATION

7.1 Operating Conditions

The machine should operate in a dry and relatively
clean environment (See Specifi cations).
7.2 Space Requirements for Machine Operation
and Maintenance Work
Minimum distance from wall (Figure 7-1):
A = 1000mm.
B = 700mm.
Minimum height = 2700mm.
Figure 7-1

7.3 Tool Kit Supplied with the Machine

A tool kit containing some tools are supplied
with the machine. These tools should be
adequate to set-up the machine, however,
other tools supplied by the customer will be
required for machine maintenance.
Figure 7-2
700rks-NA
•
To reduce the risk associated with
muscle strain:
−
Use the appropriate rigging and material
handling equipment when lifting or
repositioning this equipment.
−
Use proper body mechanics when
removing or installing taping heads that are
moderately heavy or may be considered
awkward to lift.

7.4 Machine Positioning / Bed Height

1 - Lift the machine with belts or ropes paying atten-
tion to place the belts in the points (Figure 7-2).
To set the machine bed height, do the following:
Adjust machine bed height. The case sealer is equipped
with four (4) adjustable legs that are located at the
corners of the machine frame. The legs can be adjusted
to obtain different machine bed heights from 610mm [24
inch] minimum to 890mm [35 inch] maximum.
Note – Minimum machine bed height can be
reduced to 570mm [22.5 inch] by moving
outer columns up one set of mounting
holes. However, this change also
increases minimum box height of 120 mm
[4.8 inch] to 170mm [6.8 inch].
Refer to Figure 7-3 and set the machine bed height
as follows:
2. Loosen, but do not remove, two (2) M8 x 1.25
socket head screws in one leg (use M6 hex
wrench). Adjust the leg length for the desired
machine bed height. Retighten the two screws to
secure the leg. Adjust all four (4) legs equally.
M8 x 1.25mm
Socket Head
Screws
Adjustable
Legs
Figure 7-3
21
WARNING
2010 January