Installation; Operating Conditions; Space Requirements For Machine Operation And Maintenance; Tool Kit Supplied With The Machine - 3M Matic 8000a-I Instructions And Parts List

Adjustable case sealer with accuglide 3 taping heads
Table of Contents

Advertisement

7. Installation

7.1 Operating Conditions

The machine should operate in a
dry and relatively clean environment
(See Specifications).
7.2 Space Requirements for
Machine Operation and
Maintenance Work
Minimum distance from wall
(Figure 7-1):
A = 1000mm.
B = 700mm.
Minimum height = 2700mm.
7.3 Tool Kit Supplied with Machine
A tool kit containing some tools are
supplied with the machine. These
tools should be adequate to set-up
the machine, however, other tools
supplied by the customer will be
required for machine maintenance.
7.4 Machine Set-Up / Bed Height
1 - Lift the machine with belts or
To set the machine bed height,
do the following:
2 - Adjust machine bed height.
Also refer to "Specifications"
3 - Lock the screws.
4 - Repeat the operation for all legs.
5 - For Outer Column Positioning -
3M-Matic
8000a-I / 8000a3-I - Type 11700
Page 18
44-0009-2161-7 / ECO# 0078483
ropes paying attention to place
belts in the points (Figure 7-2).
The case sealer is equipped
with four (4) adjustable legs
that are located at the corners
of the machine frame.
The legs can be adjusted to
obtain different machine bed
heights (Figure 7-3).
(It is not necessary to fix or
anchor the machine to the floor).
The columns are shipped in a
lower position.
To Adjust Columns - See Special
Set-up Procedure (Section 11).
B
A
Figure 7-2
Figure 7-1
Figure 7-3
International - ENG
February 2021

Advertisement

Table of Contents
loading

This manual is also suitable for:

Matic 8000a3-i

Table of Contents