Sony MVS-8000 User Manual page 1349

Icon Title Message
Trim The Start TC or Stop TC is not
properly set.
This file is locked.
This file is using for playback.
Warning No Switcher information
available.
Please confirm "Network
Configuration" on Page 7311.
Warning This operation will be
cancelled, because the register
is locked.
Please change the register
status to be unlocked first.
Warning Illegal Network Config
(System Information (Page 7311)
Config)
Illegal Panel Assign
Information for Dual Simul
Operation (Page 7312)
No Panel Assign Information
(Page 7312)
No Switcher Assign
Information (Page 7312)
No System Operation Mode
Information (Page 7312)
No DME Channel Information
a) MKS-8010A only
Description
2522:Frame Memory >Clip >Play
In the above menu, when [Trim] is pressed, this
message appears if neither Start TC not Stop
TC is set.
2522:Frame Memory >Clip >Play
In the above menu, when [Trim] is pressed, this
message appears if the interval between Start
TC (or Clip Begin) and Stop TC (or Clip End) is
the entire clip.
2522:Frame Memory >Clip >Play
In the above menu, when [Trim] is pressed, this
message appears if the Start TC (or Clip Begin)
value is greater than the Stop TC (or Clip End)
value.
2522:Frame Memory >Clip >Play
In the above menu, when [Trim] is pressed, this
message appears if the file is locked.
2522:Frame Memory >Clip >Play
In the above menu, when [Trim] is pressed, this
message appears if the file is being played
back.
When starting up the menu system, the
switcher is not present in the system
information. Check the Data LAN connections,
and in Menu 7311: Engineering Setup >System
>Network Config, retry [Auto Config].
6211.1: Effect >Master Timeline >Store >Edit
6311.1: Snapshot >Master Snapshot >Store
>Edit
6411.1: Shotbox >Register >Store >Edit
In the above menus, an attempt was made to
store in a locked register. Unlock the register
before carrying out the store.
When starting up the menu system, if the
system information read from the control panel
is not correct, one of these messages, that
corresponds to the situation appears.
Following the message, use Menu 7311:
Engineering Setup >System >Network Config
or 7312: Engineering Setup >System >System
Config to retry the operation.
1349
Error Messages