Assigning Preview Output To Preview Selection Buttons - Sony MVS-8000 User Manual

• M/E-3 Key1,2
• M/E-3 Key3,4
• DSK1,2
• DSK3,4
• Key1,2
• Key3,4
1) In this case, depending on the switcher extension interface port, operations always apply to
the following.
Ext Port 1: M/E-1
Ext Port 2: M/E-2
Ext Port 3: M/E-3
For the MKS-8010B, operations also apply to an M/E bank assigned to the interface port in
the Extension Panel menu (see page 1146).
• N/A (no assignment)
To assign a key to the independent key transition control block (simple type),
use the following procedure. Here the example shown is the case in which keys
3 and 4 ("Key3,4") are assigned to the second row switcher bank of the main
base.
1
In the Panel >Config menu, press [Compact Key Module Assign].
The Compact Key Module Assign menu appears.
The left side of the status area shows data for the main base (physical
layout and switcher bank names and key assignment). The right side shows
the data for the extension section (physical ports and key assignment).
2
Press directly on the display on the left, to select the control block for the
assignment.
Here, press on the intersection of the "2nd Row" column and "Module
Assign" row.
3
In the <Module Assign> group, select the key you want to assign.
In this example, select [Key3,4].
To return the key assignment to the default
In the Compact Key Module Assign menu, press [Default].
This returns all key assignments to their factory default state.

Assigning Preview Output to Preview Selection Buttons

It is possible to assign any preview output to a preview selection button.
This applies to the preview selection buttons in the fade-to-black control block
and the downstream key/fade-to-black control block.
For details of these control blocks, see Chapter 2 (Volume 1).
1)
1)
Overall Control Panel Settings (Config Menu)
1137