Nortel Meridian 1 Option 11C Expansion Manuallines page 51

Chapter 3—Add Expansion cabinets/chassis using fiber-optic connectivity
Figure 18
Fiber routing guide installed in the chassis
Cables routed around
Procedure 3
Start-up procedures for a first-time system installation of the Option
11C Mini, using the SSC card
1 Test the power outlet.
Make sure that the correct voltage of power is present before you plug
the power cord into the outlet. The source must match the label on the
back of the chassis.
2 Connect the power cord from the power connector on the back of
the chassis to an AC power source. See Figure 19. Secure the
power cable with a cable tie.
Cutout on right-hand
side of the chassis
spool
Option 11C and 11C Mini
Page 51 of 72
Expansion Guide