Nortel Meridian 1 Option 11C Expansion Manuallines page 43

Chapter 3—Add Expansion cabinets/chassis using fiber-optic connectivity
2
3
Static electricity can damage circuit cards. Wear an antistatic wrist
strap when handling circuit cards or any of their components. When
handling the cards, be careful not to damage any of their components.
4
5
Install the Option 11C Mini chassis, as described in the Option 11C
Mini Planning and Installation Guide (553-3021-209) .
a Install the Expansion chassis, including Chassis Expanders (if
Chassis Expanders are to be used).
Note 1: Connect the Main Chassis and Chassis Expander with two
NTDK95 copper cables.
b Install the system ground.
c If required, install an Uninterruptible Power Supply (UPS).
Attach an antistatic wrist strap to your wrist.
Take a Fiber Receiver card, and place it on a clean, flat surface.
Note: To support fiber-optic connectivity, you must install a Fiber
Receiver card in each Expansion chassis.
to determine the Fiber Receiver card that corresponds to the
daughterboards in the Primary Main cabinet/chassis.
Do one of the following:
— If you are using A0632902 plastic fiber-optic cable to connect the
Primary Main Chassis to the Expansion Chassis, go to Step 6 on
page 44.
CAUTION
Refer to Table 1 on page 22
Option 11C and 11C Mini
Page 43 of 72
Expansion Guide