Plastic Ties Removal; Assembly Completion - 3M Matic 8000a-I Instructions And Parts List

7. Installation
7.5 Removal of Plastic TIes
Cut the plastic which attaches the
top head to the frame and remove
the polystyrene blocks (Figure 7-4).
Cut the plastic strap which
attaches the strip and the
EMERGENCY STOP cable to the
frame (Figure 7-5). Cut the plastic
ties holding the lower taping head
in position (Figure 7-6).

7.6 Assembly Completion

1. Handle - Remove handle from
(Figure 7-7A).
2. Tape Drum Bracket - Install upper
Figure 7-7
3M-Matic 8000a-I / 8000a3-I - Type 11700
™
Page 19
44-0009-2161-7 / ECO# 0078483
(continued)
shipping position and reinstall
in operational position -
tape drum bracket on top cross
bar as shown (Figure 7-7B).
A
C
Figure 7-6
B
Figure 7-4
Figure 7-5
International - ENG
February 2021