MAINTENANCE WORK ON CHASSIS AND ENGINE
Changing the gear oil
x
11.104
Draining the gear oil
x
11.105
Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Drain the gear oil only when the engine is warm.
–
Remove gear oil level check screw
–
Check the gear oil level.
A small amount of gear oil should flow out of the hole.
»
If no gear oil flows out:
–
Add gear oil.
–
Mount and tighten the gear oil level check screw.
Guideline
Screw, gear oil level check
B00050-10
–
Drain the gear oil.
400721-01
–
Refill with gear oil.
400722-01
–
Place the motorcycle on a level surface.
–
Place a suitable container under the engine.
–
Remove the gear oil drain plug with magnet
–
Completely drain the gear oil.
–
Thoroughly clean the gear oil drain plug with a magnet.
–
Clean the sealing area on the engine.
–
Mount the gear oil drain plug with magnet
Guideline
Gear oil drain plug with magnet
B00052-10
.
(
p. 78)
x
M6
(
p. 77)
x
(
p. 78)
x
.
and the seal ring and tighten it.
M12x1.5
77
10 Nm (7.4 lbf ft)
20 Nm
(14.8 lbf ft)