Refilling With Coolant; Removing The Main Silencer - KTM 250 EXC E-Starter EU 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Refilling with coolant

x
11.83
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
–
Avoid contact between coolant and skin, eyes and clothing. If it gets into your eyes, rinse immediately with water and con-
tact a doctor. Wash affected skin areas immediately with soap and water. If coolant is swallowed, contact a doctor immedi-
ately. Change clothes that have come into contact with coolants. Keep coolant out of the reach of children.

Removing the main silencer

11.84
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down. Do not touch hot components.
–
Remove screw
–
Completely drain the coolant.
–
Mount screw
Guideline
Drain plug, water pump cover
B00044-11
–
Make sure that screw
–
Stand the motorcycle upright.
–
Fill the radiator completely with coolant.
Coolant
B00072-10
–
Position the vehicle as shown and secure it against rolling away. A height differ-
ence of must be reached.

Guideline
Height difference
Info
To ensure that all of the air can escape from the cooling system, the front of
A 0 0 A
the vehicle must be jacked up. A poorly bled cooling system is less effective
at cooling and may result in overheating of the engine.
400677-10
–
Place the vehicle back on a level surface.
–
Fill the radiator completely with coolant.
–
Mount radiator cap
–
Run the engine until it is warm.
–
Check the coolant level. (
B00073-10
. Remove radiator cap .
 
with a new seal ring and tighten it.

is tightened.

1.2 l (1.3 qt.)

.

p. 68)
M10x1 15 Nm
(11.1 lbf ft)
Coolant ( p. 96)
Coolant (mixed ready to use) (
75 cm (29.5 in)
69
p. 96)