MAINTENANCE WORK ON CHASSIS AND ENGINE
Adjusting the play of the steering head bearing
11.24
Removing the fork legs
x
11.25
Installing the fork legs
x
11.26
x
–
Jack up the motorcycle. (
–
Loosen screws
–
Loosen and retighten screw
Guideline
Screw, top steering head
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Tighten screws
Guideline
Screw, top triple clamp
800016-10
–
Tighten screw
Guideline
Screw, top steering stem
–
Check the play of the steering head bearing. (
–
Remove the front wheel.
–
Remove screws
–
Remove cable binder
–
Remove screws
–
Hang the brake caliper and the brake line loosely to the side.
100802-10
–
Loosen screws
–
Loosen screws
100804-10
–
Position the fork legs.
Info
The topmost sunk nut in the fork leg must be flush to the upper edge of the
upper triple clamp.
Position bleeder screws
B00018-10
p. 34)
and
.
.
M20x1.5
.
M8
.
M8
(
p. 57)
x
and take off the clamp.
.
and take off the brake caliper.
. Remove the fork leg on the left.
. Remove the fork leg on the right.
toward the front.
10 Nm (7.4 lbf ft)
20 Nm
(14.8 lbf ft)
20 Nm
(14.8 lbf ft)
p. 41)
42