Preparations For Riding On Wet Sand - KTM 250 EXC E-Starter EU 2010 Owner's Manual

GENERAL TIPS AND HINTS ON PUTTING INTO OPERATION

Preparations for riding on wet sand

8.5
–
Mount the dust cover for the air filter.
Dust cover for air filter (59006019000)
Info
Read the KTM PowerParts installation instructions.
600869-01
–
Mount the dust cover for the air filter for sand.
Sand cover for air filter (59006022000)
Info
Read the KTM PowerParts installation instructions.
–
Adjust the carburetor jetting and setting.
Info
600871-01
Recommendations on the carburetor setting are available from your autho-
rized KTM workshop.
–
Clean the chain.
Chain cleaner (
–
Mount the steel sprocket.
Tip
Do not grease the chain.
–
Clean the radiator fins.
–
Carefully align bent radiator fins.
600868-01
–
Check the radiator cap.
Value on the radiator cap
» If the displayed value does not equal the setpoint value:
600872-10
–
Change the radiator cap.
–
Seal the air filter box.
Tip
Seal the air filter box at the edges to prevent dirt from entering.
–
Clean the air filter.
Info
Check the air filter approx. every 30 minutes.
p. 98)
1.8 bar (26 psi)
Warning
Danger of scalding During motorcycle operation, the coolant gets
very hot and is under pressure.
–
Do not remove the radiator cap, radiator hoses or other cooling
system components when the engine is hot. Allow the engine
and cooling system to cool down. In case of scalding, rinse
immediately with lukewarm water.
x
( p. 72)
x
25