Removing The Front Wheel - KTM 250 EXC E-Starter EU 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Removing the front wheel

11.59
–
Remove the rear brake linings.
–
Stand the vehicle upright.
–
Remove screw cap
–
Press the brake piston back to its basic position and make sure that no brake fluid
overflows from the brake fluid reservoir.
–
Install the rear brake linings.
–
Add brake fluid to level
Brake fluid DOT 4 / DOT 5.1 (
400233-10
–
Mount the screw cap with the membrane and the O-ring.
Info
Clean up overflowed or spilt brake fluid immediately with water.
x
–
Jack up the motorcycle. (
–
Press the brake caliper onto the brake disc by hand in order to push back the brake
pistons.
Info
Make sure when pushing back the brake pistons that you do not press the
brake caliper against the spokes.
B00055-10
–
Remove screw
–
Loosen screws
500084-10
–
Holding the front wheel, withdraw the wheel spindle. Take the front wheel out of
the fork.
Info
Do not pull the hand brake lever when the front wheel is removed.
Always lay the wheel down in such a way that the brake disc is not dam-
aged.
500085-10
–
Remove spacers
500086-10
( p. 55)
x
with membrane and the O-ring.
 
x ( p. 56)
.

p. 96)
p. 34)
.

.

.

57