MAINTENANCE WORK ON CHASSIS AND ENGINE
Handlebar position
11.33
A
0 0 A
A
0 0 A
B
0 0 B
Adjusting the handlebar position
11.34
Warning
Danger of accidents Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
1
0 0 1
2
0 0 2
Checking the play in the throttle cable
11.35
On the upper triple clamp, there are two holes a distance of
Hole distance A
The holes on the handlebar support are placed at a distance of
Hole distance B
0 0 B
B
The handlebar can be mounted in four different positions. In this way, the handlebar
can be mounted in the position that is most comfortable for the rider.
400223-11
x
–
Remove the four screws
0 0 1
1
and lay it to one side.
0 0 2
2
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
–
Remove the two screws
–
Place the handlebar support in the required position. Mount and tighten the two
400223-10
screws
.
Guideline
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamp. Mount and evenly tighten the four screws
Guideline
Screw, handlebar clamp
–
Move the handlebar to the straight-ahead position.
–
Push back bellows
–
Pull back the throttle cable casing until you sense a resistance.
–
Now check throttle cable play
Play in throttle cable
»
If the throttle cable play does not meet specifications:
–
Adjust the play in the throttle cable.
–
Push on bellows
B00026-10
15 mm (0.59 in)
3.5 mm (0.138 in)
. Remove the handlebar clamp. Remove the handlebar
. Remove the handlebar support.
M10
M8
.
.
3... 5 mm (0.12... 0.2 in)
x
. Check the throttle grip for smooth operation.
apart.
from the center.
40 Nm
Loctite
®
243™
(29.5 lbf ft)
.
20 Nm
(14.8 lbf ft)
(
p. 46)
45