Checking The Rear Brake Fluid Level; Adding Rear Brake Fluid - KTM 250 EXC E-Starter EU 2010 Owner's Manual

Table of Contents

Advertisement

MAINTENANCE WORK ON CHASSIS AND ENGINE

Checking the rear brake fluid level

11.53
Warning
Danger of accidents Failure of the brake system.
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding. (Your authorized KTM workshop will be glad to help.)
Warning
Danger of accidents Reduced braking effect caused by old brake fluid.
Change the brake fluid of the front and rear brakes according to the service schedule. (Your authorized KTM workshop will
be glad to help.)

Adding rear brake fluid

x
11.54
Warning
Danger of accidents Failure of the brake system.
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding. (Your authorized KTM workshop will be glad to help.)
Warning
Skin irritation Brake fluid can cause skin irritation on contact.
Avoid contact with skin and eyes, and keep out of the reach of children.
Wear suitable protective clothing and goggles.
If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.
Disconnect spring
Loosen nut
travel.
To adjust the basic position of the foot brake lever individually, loosen nut
turn screw
Info
The range of adjustment is limited.
Turn push rod
B00008-10
basic position of the foot brake lever.
Guideline
Free play of foot brake lever
Hold screw
Guideline
Remaining screws, chassis
Hold push rod
Guideline
Remaining nuts, chassis
Attach spring
Stand the vehicle upright.
Check the brake fluid level in the viewer
»
If an air bubble is visible in viewer
Add rear brake fluid.
400234-10
.
and, with push rod
, turn it back until you have maximum free
accordingly.
accordingly until you have free travel
and tighten nut
.
and tighten nut
.
.
(
p. 54)
x
. If necessary, adjust the
3... 5 mm (0.12... 0.2 in)
M8
25 Nm
(18.4 lbf ft)
M6
15 Nm
(11.1 lbf ft)
.
:
54
and

Advertisement

Table of Contents
loading

Table of Contents