Installing The Front Wheel; Removing The Rear Wheel - KTM 250 EXC E-Starter EU 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Installing the front wheel

11.60
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.

Removing the rear wheel

11.61
x
–
Clean and grease shaft seal rings
Long-life grease (
–
Insert the spacers.
500086-11
–
Lift the front wheel into the fork, position it, and insert the wheel spindle.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Operate the hand brake lever several times until the brake linings are lying correctly
on the brake disc.
–
Remove the motorcycle from the work stand. (
500084-11
–
Pull the front wheel brake and push down hard on the fork several times to align
the fork legs.
–
Tighten screws
Guideline
Screw, fork stub
x
–
Jack up the motorcycle. (
–
Press the brake caliper onto the brake disc by hand in order to push back the brake
piston.
Info
Make sure when pushing back the brake piston that you do not press the
brake caliper against the spokes.
–
Remove nut
–
Remove chain adjuster
wheel to be pushed forward.
–
Push the rear wheel forward as far as possible. Remove the chain from the rear
sprocket.
–
Holding the rear wheel, withdraw the wheel spindle. Take the rear wheel out of the
swingarm.
Info
Do not operate the foot brake when the rear wheel is removed.
Always lay the wheel down in such a way that the brake disc is not dam-
aged.
400258-10
and bearing surface

p. 98)
.

.

p. 34)
.

. Withdraw wheel spindle

of the spacers.

M24x1.5 45 Nm
(33.2 lbf ft)
p. 34)
M8 15 Nm
(11.1 lbf ft)
only enough to allow the rear

58