MAINTENANCE WORK ON CHASSIS AND ENGINE
Installing the rear wheel
11.62
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
–
Remove spacers
400260-11
x
–
Clean and grease shaft seal rings
Long-life grease (
–
Insert the spacers.
400260-10
–
Lift the rear wheel into the swing arm, position it, and insert wheel spindle
–
Apply the chain.
400259-10
–
Position chain adjuster
–
Check the chain tension. (
–
Make sure that chain adjusters
–
Tighten nut
Guideline
Nut, rear wheel spindle
Info
The wide adjustment range of the chain adjusters (32 mm) enables different
secondary transmissions with the same chain length.
Chain adjusters
–
Operate the foot brake lever repeatedly until the brake linings lie on the brake disc
and there is a pressure point.
–
Remove the motorcycle from the work stand. (
400225-12
.
and bearing surface
p. 98)
. Mount nut
, but do not tighten it yet.
p. 47)
are fitted correctly on adjusting screws
.
can be turned by 180°.
of the spacers.
M20x1.5
80 Nm (59 lbf ft)
p. 34)
59
.
.