Viewing The Power Supply Status - Alcatel-Lucent OmniSwitch 6250-M Hardware User's Manual

Console Port

Viewing the Power Supply Status

The switch constantly monitors the power supply operation. If either the primary or backup power source
(optional) unexpectedly shuts down, the switch sends out a notification to the user. In addition, the power
LED on the chassis front panel displays solid amber.
Note. For detailed OmniSwitch 6250 Series LED information, refer to
To check the number of power supplies currently operating, and the status of each power supply, use the
show power command. For example:
-> show power
Power Supplies in chassis 1
PS Operational Status
---------+-------------------
PS-1 UP
PS-2 NOT PRESENT
The primary (i.e., factory-installed) power supply is listed as PS-1 in the show power command output.
The backup power supply is listed as PS-2. In the example above, there is no backup power supply
installed.
page 4-4
Preliminary
9/28/09
OmniSwitch 6250 Series Hardware Users Guide
Booting 6250 Series Switches
"Status LEDs" on page 2-16.
September 2009