Genie RMZ Z Series Manual page 12

Section 2: Rolling Steel Operator Installation
Rolling Steel/Grill Doors. FIG. 1
Wall Mount:
The Rolling Steel Door Operator is configured at the factory for right-hand or left-hand (Hoist & Jackshaft)
Front of Hood, Top of Hood and Wall Mount.
1. Mounting hardware and instruction will be supplied based on door specifications. (Typical mounting
arrangements shown.)
2. Operator must be fastened to the door framing material with suitable hardware designed for the
mounting surface (i.e. wood, masonry etc.
Installation:
3. Install 12 tooth sprocket (C) on operator output shaft.
4. Align keyways and insert key into sprocket and output shaft keyway. Do not tighten set screw at this time.
5. Install door sprocket (D) on door shaft. Align keyways and insert key into sprocket and door shaft keyway.
Do not tighten set screws at this time.
6. Assemble chain (E) using chain master link.
7. Place assembled chain over door shaft sprocket and around the 12 tooth sprocket.
8. Using the slots in the mounting bracket (A), adjust the operator to remove slack from the chain. Be certain
operator output shaft is parallel with the door shaft.
9. Align and square operator. Mark within slotted mounting holes on operator and install mounting hardware.
10. Tighten operator mounting bracket hardware.
11. Install suitable hardware in, at least 2, of the 4 lock down holes located in each corner of the mounting
brackets (B).
12. Tighten sprocket set screws.
Finish Installation:
See page 2.6 for Chain Hoist Installation
See page 2.7 for Clutch Adjustment and Release cord installation.
E
Sec-2.5
D
C
B x4
A
WALL MOUNTING
Parallel