Genie RMZ Z Series Manual page 28

Non-Monitored Safety Edge
Actuating the operator by using constant contact on the CLOSE button will override non-functioning
external reversing devices, including sensing edges.
L'activation de l'operateur en util isant un contact constant sur le bouton FERMER annulera les dispositifs
d'inversions externes, y compris les systèmes de détection des bords.
1. Route wires into operator electric box using suitable conduit and clamp systems.
2. Attach wires to N-O SAFETY terminals on control wire terminal strip.
External Radio Installation (Optional)
Installing external radio for remote operation. FIG. 8
1. Make wire connections to External Radio harness (provided) as shown.
2. Install harness to external radio harness plug on control board as shown.
NOTE: A monitored safety device must be used when installing an external radio for remote operation. Operator
controls must be set for Momentary Contact for remote operation.
Sec-3.14
Section 3: Wiring
WARNING
!
AVERTISSEMENT
!
CONTROL SIGNAL
TERMINAL STRIP
N-O N-O
SAFETY SAFETY
External Radio Harness
Blue Yellow
Orange
Relay GND
NOM
+24 VDC
3 Wire Radio
Non-Monitored
Safety Edge
External Radio Harness
Blue Yellow
Orange
Relay GND
NOM
+24 VDC GND
FIG. 8
4 Wire Radio
-