Line Voltage - Genie RMZ Z Series Manual

Line Voltage Wiring
1. Remove LINE VOLTAGE INPUT PLUG and install proper fittings and 1/2"conduit.
2. Route proper LINE VOLTAGE wires into operator.
3. Locate LINE INPUT terminals on circuit board. Using correct connectors, attach wires to LINE INPUTS, and
GROUND terminal.
• Keep low voltage and line voltage wires separate.
• Route all line voltage wires as shown.
• Plug all unused conduit holes.
LINE
GROUND
ROUTE LINE VOLTAGE
WIRING IN SHADED
AREA AS SHOWN
Section 3: Wiring
DO NOT DRILL ELECTRIC BOX
Remove plugs to install wiring
-
HIGH VOLTAGE
INPUT PLUG
LINE INPUT
TERMINALS
HIGH VOLTAGE
INPUT PLUG
LINE IN
POWER CONNECTIONS
L1
N
LINE
NEUTRAL
120V
(HOT)
GND
Sec-3.3