Card Shot - Sharp MX-M350U Operation Manual

Card shot

When copying a card, this function allows you to combine the front and back sides on a single sheet of paper.
This function is convenient for making copies for certification purposes and helps save paper.
Original
CARD
CARD
Front of
card
Back of
card
Example:
Portrait
8-1/2" x 11" (A4)
size
1 Touch the [PAPER SELECT] key and then
select the desired paper size.
READY TO SCAN FOR COPY.
1. 8 x11 1 / PLAIN
2
8 x11 1 / 2. 11x17 PLAIN
2
PLAIN 3. 11x17
PLAIN
4. 8 x11 1 / PLAIN
2
NOTE
If paper of the desired size is not loaded in any tray,
load paper of the required size in a paper tray or the
bypass tray. (See "Setting the paper type and paper
size" on page 2-5.)
To display the special modes screen...
See "General procedure for using special
functions" on page 5-2.
Touch the [CARD SHOT] key in the special
2
modes screen (2nd screen).
TRANSPARENCY
MULTI SHOT
INSERTS
MIRROR

CARD SHOT

IMAGE
Copy
CARD
Example:
Landscape
8-1/2" x 11" (A4)
size
The selected paper size
key is highlighted and
the paper selection
screen closes.
The CARD SHOT
setting screen will
appear. A card shot
icon ( , etc.) will also
appear in the upper left
corner of the screen to
indicate that the
function is turned on.
● Copying is only possible on standard size paper.
● A copy ratio cannot be selected when using this
function.
● The image cannot be rotated when using this
function.
3 Enter the X dimension (width) and Y
dimension (length) of the original with the
keys.
CANCEL OK
SIZE RESET
FIT TO
PAGE
●X (width) is initially selected. Enter X and then
touch the Y ( ) key to enter Y.
●To return the X and Y values to the initial
settings configured in the administrator
settings, touch the [SIZE RESET] key. (See
"CARD SHOT SETTINGS" on page 17 of the
administrator settings guide).
●To have the images enlarged or reduced by a
suitable ratio based on the entered original
size so that the front and back sides fit into the
selected paper size, touch the [FIT TO PAGE]
key.
SPECIAL MODES
5
5-27