Transmitting The Front And Back Sides Of A Card On One Sheet Of Paper (Card Shot) - Sharp MX-M350U Operation Manual

SPECIAL MODES
■ USING 2IN1
1 Switch to the desired mode and touch the
[SPECIAL MODES] key.
ADDRESS REVIEW
SPECIAL MODES
ENTRY FILE
TTINGS
QUICK FILE
Touch the [2in1] key.
2
AM ERASE
R
2in1
TRANSMITTING THE FRONT AND BACK SIDES OF A CARD
ON ONE SHEET OF PAPER (CARD SHOT)
When scanning a card, this function allows you to combine the front and back sides on a single sheet of paper. To
use this function, the original must be scanned on the document glass.
Your machine
CARD SHOT
Front of card
Back of card
NOTES
● After "CARD SHOT" is selected, the send size can be changed. For the procedure for changing the send size,
see page 2-17.
● Transmission is not possible if the image is too large to fit into the transmission size.
● A ratio cannot be specified and the image cannot be rotated when using this function.
If the address book screen
appears, touch the
[CONDITION SETTINGS]
key to display the
condition settings screen
(page 1-13).
The [2in1] key
highlighted.
To cancel the selection,
touch the key once again
CA
so that it is not
highlighted.
Transmission using the "card
shot" special function
Transmission to
other machine
3 Touch the [OK] key.
SPEAKER RESEND
DUAL PAGE
SCAN
Perform the send procedure as explained
4
in "SENDING AN IMAGE".
●For scan mode, see
●For Internet fax mode, see
is
NOTE
To cancel 2in1...
Touch the highlighted key in the screen of step 2 and
then touch the [OK] key.
The other machine
The front and back of the card
are scanned on one page.
3-8
You will return to the
screen of step 1.
OK
page 2-2.
page 2-6.