List Print; Security Settings; Change Admin Password - Sharp MX-M350U Operation Manual

GENERAL SETTINGS
PING command
This setting is used to check if the machine and a
computer connected to the network can communicate.
Enter the IP address of the computer that you wish to
check and touch the [START] key. A message will
appear indicating whether or not there was a response
from the computer.

Security settings

The following settings are related to security. Touch the
[SECURITY SETTINGS] key to configure the settings.
When any of these settings are changed, you must exit
the administrator settings, turn off the main switch, wait
a brief interval, and then turn the main switch back on
to make the new settings take effect.
SSL setting
SSL can be used for data transmission over a network.
SSL is a protocol that enables the encryption of
information communicated over a network. Encrypting
data makes it possible to transmit and receive sensitive
information safely.
Server port
● HTTPS:
Apply SSL encryption to HTTP
communication.
● IPP-SSL:
Apply SSL encryption to IPP
communication.
Client port
● FTPS:
Apply SSL encryption to FTP
communication.
● SMTP-SSL: Apply SSL encryption to SMTP
communication.
● POP3-SSL: Apply SSL encryption to POP3
communication.
Level of encryption
The encryption strength can be set to one of 3 levels.
Enable IPsec
IPsec can be used for data transmission/reception on a
network. When IPsec is used, data can be sent and
received safely without the need to configure settings
for IP packet encryption in a Web browser or other
higher-level application.
This setting is only used to enable or disable IPsec;
detailed IPsec settings are configured in the Web pages.
Some Web page settings may not allow connection to
the machine, or the settings may not allow printing,
scanning, or Web page display. In this case, deselect
[ENABLE IPsec] in this screen and change the Web
page settings.
SYSTEM SETTINGS
SECURITY SETTINGS
SSL SETTINGS
ENABLE IPsec
14

List print

This setting is used to print lists and reports that can
only be printed from the administrator settings.
• Touch the [ADMINISTRATOR SETTINGS LIST] key
to print one of the following groups:
Copy, printer, fax/image send, document filing,
general, security, all administrator settings lists
• Touch a key other than the [ADMINISTRATOR
SETTINGS LIST] key to begin printing a list or report.
Sharp OSA settings
The following settings are related to Sharp OSA. Touch
the [Sharp OSA SETTINGS] key to configure the
settings.
● Default display setting
● External account setting
Default display setting
The default
[DOCUMENT FILING] key is pressed can be specified.
Select either the base screen of document filing mode
or the external application selection screen. This
setting can only be configured when the application
communication module is installed. The setting also
appears in the document filing settings.
When the [CA] key ([Clear all] key) is pressed in
document filing mode or Sharp OSA mode, the initial
screen of the mode appears, regardless of the default
display setting.
External account setting
When [ENABLE EXTERNAL ACCOUNT CONTROL]
is enabled, the machine enters external count mode.
When both
CONTROL] and [ENABLE AUTHENTICATION BY
EXTERNAL SERVER] are enabled, the machine
enters external authentication mode. This item can
only be selected when the external account module is
installed.

Change admin password

This setting is used to change the administrator
password that must be entered to configure the
administrator settings. When the machine is first used,
the administrator should change the administrator
password that was set at the factory to the desired
5-digit code. Only one administrator password can be
set.
The factory default setting for the administrator
password is 00000.
OK
screen that appears
[ENABLE EXTERNAL
when the
ACCOUNT