Disposal Of Hole Punch Scrap - Sharp MX-M350U Operation Manual

Turn roller rotating knob A in the direction
9
of the arrow to move the staple unit to the
front.
Roller rotating
knob A
Staple unit
10
Remove the staple box.
11
Raise the lever at the end of the staple box.

■ Disposal of hole punch scrap

1 Unlatch the saddle stitch finisher and slide
it away from the machine.
Pull out the punch scrap collecting
2
container and empty it.
Turn the roller rotating
knob until the triangle
mark is aligned with the
index.
Remove the top staple if
it is bent. If bent staples
remain, a staple jam will
occur again.
Empty the punch debris
into a plastic bag or
other container for
disposal, taking care not
to spill any of the punch
debris.
SADDLE STITCH FINISHER
12 Return the lever to its original position.
13
Reinstall the staple box.
14
Push the stapler section back into the finisher.
15
Close the front cover.
16
Push the saddle stitch finisher back against the
machine.
NOTE
Make a test print or copy in the staple sort mode to
ensure that stapling is performed properly.
3 Return the punch
container to its original position.
Push the saddle stitch finisher back
4
against the machine.
Push the staple box in
until it clicks into place.
scrap collecting
3-21
3