Table of Contents
Advertisement
Quick Links
Operation Manual
Decorative appliance, not certified as a space heater
Recommended for a new build installation into a false (mock) chimney.
Not suitable for retrofitting into an existing masonry fireplace.
•
Appliance must be installed with a Rinnai supplied flue system.
•
Appliance must be installed, commissioned and serviced by a licensed tradesperson in
accordance with these instructions and all applicable local rules and regulations.
•
Please retain this manual for future reference.
Symmetry RDV3600
Advertisement
Table of Contents
Related Manuals for Rinnai Symmetry RDV3600
Summary of Contents for Rinnai Symmetry RDV3600
- Page 1 Recommended for a new build installation into a false (mock) chimney. Not suitable for retrofitting into an existing masonry fireplace. • Appliance must be installed with a Rinnai supplied flue system. • Appliance must be installed, commissioned and serviced by a licensed tradesperson in accordance with these instructions and all applicable local rules and regulations.
- Page 2 3 below, Rinnai new Zealand Limited supervising gas fitter’s registration number (“Rinnai”) will, at its own discretion, either and the gas fitting certification number. replace or repair any defective product at 4. This warranty commences from the date of no charge to the customer.
-
Page 3: Table Of Contents
Troubleshooting Abnormal flame pattern Optional accessories Commissioning installer details WARNING improper installation, adjustment, alteration, service or maintenance can cause property damage, personal injury or loss of life. For assistance or additional information contact Rinnai on 0800 RINNAI (0800 746 624). -
Page 4: Introduction
A focal point in any room The Rinnai Symmetry RDV3600 has been developed to provide all the same great styling as the Rinnai Symmerty RDV3610 but at a lower efficiency and lower cost. The Rinnai Symmetry RDV3600 is ideally suited to areas as a secondary heating source. -
Page 5: Safety
Do not curtains unplug the or other appliance combustible while it is materials to operating. come into Do not contact with use power the appliance. boards or double adaptors to operate this appliance. Rinnai new Zealand RDV3600 Operation Manual: 11743-A 01-10... -
Page 6: Installation Process
Constructs frame. Electrician installs electrical connection. Standard electrical termination is to the right hand side of the appliance. Gasfitter Installs flue, completes gas connection and completes installation of the Symmetry. Builder Installs cladding. Rinnai new Zealand RDV3600 Operation Manual: 11743-A 01-10... -
Page 7: Clearances
9mm eterpan MD (medium density) is supplied by PBS Ltd (www.pbs.co.nz). Other materials may also be suitable, please seek advice from a cladding supplier as to the correct application and specification of the material. Rinnai new Zealand RDV3600 Operation Manual: 11743-A... -
Page 8: Mantels, Surrounds, And Hearths
(D) of 100 mm will require 350 mm (C) of side clearance. Hearths A hearth is not necessary but can be used for decorative purposes or protection of sensitive flooring if required. It must not obscure the front of the fire. Rinnai new Zealand RDV3600 Operation Manual: 11743-A 01-10... -
Page 9: General Information
Rinnai Symmetry RDV3600. Cladding and finishes The Symmetry RDV3600 comes in two framing options; framed and frameless. Framed is best suited to a dry wall/plaster finish, the frameless option suits cladding with a finished edge such as tiles, brick or polished granite. Both options are shown below to highlight the difference. -
Page 10: Maintenance And Servicing
Regular maintenance/servicing is not covered by the Rinnai warranty. Do not attempt to carry out any service work other than that mentioned in the troubleshooting section. if you have any other faults or problems, please refer to your installer or call Rinnai. Safety devices Your Rinnai Symmetry RDV3600 is designed with the following safety devices. - Page 11 Refer to the Troubleshooting section for further information. tV installation (not suitable) A tV is not suitable for installation above the Symmetry RDV3600 due to the heat heat produced directly above the unit. Rinnai new Zealand...
-
Page 12: Remote Control
If the remote control is not going to be used for a long period, remove batteries as this will help avoid damage from leaking batteries. to replace batteries, slide open the cover located on the back of the remote control. install batteries ensuring that the correct polarity is observed. Rinnai new Zealand RDV3600 Operation Manual: 11743-A 01-10... -
Page 13: Operation Using The Remote Control
Under lock out the Power LED will remain illuminated. To start the appliance again, press and release the ON/OFF twice after gas supply resumes. in the event of a power failure the Symmetry RDV3600 will turn off and will need to be manually turned on again when power is restored. This is a safety feature. -
Page 14: Troubleshooting
Small soot deposit on normal operation no action required logs Severe soot deposits Inadequate flue system, incorrect Contact a Rinnai Service Centre forming on logs or gas pressure or log misalignment glass Condensation on glass normal operation Allow heater to warm up and condensation will... -
Page 15: Abnormal Flame Pattern
Abnormal flame pattern Each Rinnai Flame Fire has a distinct flame pattern. This should look the same every time you start your fire, after an initial warm up period of approximately 20 minutes. Abnormal flame performance and/or pattern can indicate a problem with your fire, such as blocked gas injectors or artificial logs/burn media have shifted from when the fire was first installed. -
Page 16: Optional Accessories
Outer Frames Black integrated mesh, designed to click into place over your fire to Dress Guard protect against touching the hot surface of the glass. Rinnai new Zealand RDV3600 Operation Manual: 11743-A 01-10... -
Page 17: Optional Accessories
Optional accessories Enhance your flame picture with a Rinnai Rockwool pack. The pack Additional burn contains fine ceramic fibres that will emit a beautiful glow to look like media* burning embers. Enhance the look of your fire by installing ceramic thermal liners. These... -
Page 18: Commissioning
Checklist Appliance positioned in a suitable location (clearances, combustible clearances, mantels and surrounds etc.). Rinnai flue system installed and tested to ensure effective draw. Gas pressure checked and set. Burn media installed as per instructions. Appliance tested for correct operation and to ensure no gas leaks. -
Page 19: Installer Details
Company name:______________________________________________________________ installer name:_______________________________________________________________ Address:____________________________________________________________________ ___________________________________________________________________________ Phone:_______________________________ Mobile:______________________________ Certificate of Compliance number for installation:____________________________________ Signed:______________________________ Date:_______________________________ Rinnai new Zealand RDV3600 Operation Manual: 11743-A 01-10... - Page 20 Websites: www.rinnai.co.nz and www.rinnai-tradesmart.co.nz All Rinnai appliances meet or exceed the safety standards required by New Zealand gas and electrical regulations. Rinnai is constantly improving its products and as such information and specifications are subject to change or variation without notice.